[PCB_FORUM] Re: What is the user setting that allows me to change logic in a design?

Hello,

The setting is "logic_edit_enabled".  You can find it under User
Preferences under the
Category Misc.

Mike




"Gene Carman" <gcarman@xxxxxxxxxxxxxxx>@freelists.org on 02/17/2006
06:33:50 PM

Please respond to icu-pcb-forum@xxxxxxxxxxxxx

Sent by:    icu-pcb-forum-bounce@xxxxxxxxxxxxx


To:    <icu-pcb-forum@xxxxxxxxxxxxx>
cc:
Subject:    [PCB_FORUM] What is the user setting that allows me to change
       logic in a design?


I cannot recall the setting right off hand, and I know I have set to not
allow me to change logic...  but I can't find the darn setting.


(See attached file: C.htm)
I cannot recall the setting right off hand, and I know I have set to not allow me to change logic...  but I can't find the darn setting. 
 
 

Other related posts: