[PCB_FORUM] Valor and Pads .asc files

Hello all,
I know this is an "off topic" question for this forum, so I  apologize
beforehand, but I am hoping someone out there can help me. I need to run a
valor check on pads .asc files but have never done so. I know how to do it
with rs274x/d and odb++ but not pads .asc files. Is it a similar process? If
not is it very complicated or just a simple twist on the other two? I do not
need to generate the files from pads, just load them into Valor. Please feel
free to contact me offline at dharma@xxxxxxx or 603-886-8711 x212 so as not
to inundate others with any responses.
Thanks in advance,
Dharma
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.

Other related posts: