[PCB_FORUM] Re: Tooling holes

Ummm....I have witness the fabrication of numerous panels and have NEVER
seen a FABRICATOR use customer tooling holes.
The artwork is located by the fabricators own tooling holes.
ASSEMBLERS use customer tooling holes, is that what you were thinking?

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of FrankW
Sent: Tuesday, March 24, 2009 11:45 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Tooling holes

Bill Dempsey wrote:
>
> 1)      Fabricators do NOT use your PCB tooling holes as their tooling 
> holes. 
>

Actually Bill they do use the on-board .125 tooling holes In Fact they 
hope the customer provides
them. If not they may ask if they can insert a couple. This is mainly 
for routing the board out of
their mfg panel. If no tooling holes are available, they then have to 
secure the PCB using double
sided tape or similar.
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: