[PCB_FORUM] Re: Tooling holes
- From: FrankW <fworm@xxxxxxxxx>
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Tue, 24 Mar 2009 12:45:02 -0400
Bill Dempsey wrote:
1) Fabricators do NOT use your PCB tooling holes as their tooling
holes.
Actually Bill they do use the on-board .125 tooling holes In Fact they
hope the customer provides
them. If not they may ask if they can insert a couple. This is mainly
for routing the board out of
their mfg panel. If no tooling holes are available, they then have to
secure the PCB using double
sided tape or similar.
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
Other related posts: