[PCB_FORUM] Re: To Mentor...

Hi Gary,

> So if you wanted to move around some parts, you would have to
> chose a part,
> get in the move command, move it, select another part, get in the move
> command again, move it, etc., etc.?  That sounds ridiculous!  I hope it's
> not that bad!!

For PADS, and I can not speak of Expedition, as I have never used it, you do
have to choose one or more parts, then select move and then move them.
Select more parts, select move (right mouse button) then move them.  Allegro
is "modal", as in, you set the mode, say, "move", then you are in move mode
until you get out of it.  PADS does not work this way.  You select something
(typically using the selection filter) and right mouse to see what you can
do with it.  It really is quite easy to use.

> Did you find that Allegro was easier to use after using Mentor, or vice
> versa?

I find PADS much easier, but not nearly as powerful.

Regards,

Austin

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: