[PCB_FORUM] Re: The router...
- From: "Musetti, Carl" <cmusetti@xxxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Fri, 8 Jul 2005 14:46:43 -0400
I am on performance and it doesn't open up a specctra window unless I type in
specctra at a dos command line or I also use a thing called cygwin which is a
unix term emulation which I can type it in there and it will bring up a
specctra window
-----Original Message-----
From: Eric Hufstedler [mailto:ehufstedler@xxxxxxxxxxxxxxx]
Sent: Friday, July 08, 2005 2:43 PM
To: 'icu-pcb-forum@xxxxxxxxxxxxx'
Subject: [PCB_FORUM] Re: The router...
I was wondering if that was still spectra. I am on studio, and was surprised
when autoroute didn't open up a spectra window.
I barely used it this time, but it sure seemed easier to sewt up than when i
really used way back in PSD14 (i think).
Eric
-----Original Message-----
From: Bye, Randy W [mailto:Randy.Bye@xxxxxxxxxx]
Sent: Friday, July 08, 2005 11:15 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: The router...
Tom,
The auto-router built into Allegro is the Specctra router. Many folks regard
it as the best in the business for auto-routing. In addition to auto-routing
it has excellent interactive route editing capability too. I find that there
are some things I like doing with the Specctra route editor and others with the
Allegro route editor.
Regards,
Randy
Randy Bye
PCB Engineering
UNISYS , Imagine it. Done.
PO Box 64942
St. Paul MN. 55164
MS: 4713
Voice (651)635-3998
Fax (651)635-6329
E-mail: randy.bye@xxxxxxxxxx
THIS COMMUNICATION MAY CONTAIN CONFIDENTIAL AND/OR OTHERWISE PROPRIETARY
MATERIAL and is thus for use only by the intended recipient. If you received
this in error, please contact the sender and delete the e-mail and its
attachments from all computers.
_____
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Tom Robinson
Sent: Friday, July 08, 2005 7:54 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] The router...
Hi George:
The router that is built into Allegro is it a good one? Is it the one they use
in Orcad Layout?
Best regards,
tr :)
This message and any file transmitted with it may contain confidential
information and is exempt from disclosure under applicable law. The information
contained in this message and any file transmitted with it is transmitted in
this form based on a reasonable expectation of privacy. Any disclosure,
distribution, copying or use of the information by anyone other than the
intended recipient, regardless of address or routing, is strictly prohibited.
If you have received this message in error, please advise the sender by
immediate reply and delete the original message. Personal messages express
views solely of the sender and are not attributable to Biodex Medical Systems,
Inc.
Other related posts:
