[PCB_FORUM] Re: Text edit dialog box??? ver 16

Barbra, et. al. The text edit mode comes up when you are using ver 16,
are in the General Edit application mode, when you select text, and then
invoke Edit > Text.  

 

The Text Edit dialog box comes up...  which allows such wonderful things
such as the ability to cut and paste text from other windows.  

 

 

 

 

 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Barbara Seeger
Sent: Monday, December 10, 2007 3:23 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Text edit dialog box??? ver 16

 

Any chance you are thinking of add text, pick location, RMB read from

file?

 

Regards,

Barbara Seeger - Cadence 

 

 

On Mon, 2007-12-10 at 17:54, Gene Carman wrote:

> I think I stumbled across a text edit dialog box the other day?  one

> that even allowed cut and paste.  But now I can?t seem to make that

> happen again?  all I get is the on board text editor which doesn?t

> allow cut and paste.  

> 

>  

> 

> Perhaps I am not in the right mode or something.  

> 

>  

> 

> Has anyone else seen this text dialog box?  

> 

> 

-----------------------------------------------------------

To subscribe/unsubscribe: 

Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx

with a subject of subscribe or unsubscribe

 

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

 

Problems or Questions:

Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

-----------------------------------------------------------

JPEG image

Other related posts: