[PCB_FORUM] Re: Text edit dialog box??? ver 16

No that's not it.  

And possibly I was in another tool...  sigh...  you know sometimes all
these tools run together in my mind.  

It may not have been Allegro.  It just seemed so...  familiar.  Oh well.




-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Barbara Seeger
Sent: Monday, December 10, 2007 3:23 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Text edit dialog box??? ver 16

Any chance you are thinking of add text, pick location, RMB read from
file?

Regards,
Barbara Seeger - Cadence 


On Mon, 2007-12-10 at 17:54, Gene Carman wrote:
> I think I stumbled across a text edit dialog box the other day?  one
> that even allowed cut and paste.  But now I can?t seem to make that
> happen again?  all I get is the on board text editor which doesn?t
> allow cut and paste.  
> 
>  
> 
> Perhaps I am not in the right mode or something.  
> 
>  
> 
> Has anyone else seen this text dialog box?  
> 
> 
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: