[PCB_FORUM] Re: Symbol without pins

Hello again.
 
Sorry, I found the answer in Sourcelink:
Solution 11061434
 
    William.
 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx 
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of William Billereau
Sent: 13 December, 2005 2:52 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Symbol without pins


Hello All.
 
Is there a way to use a Concept symbol without any logic function (no pins at 
all) associated to an Allegro JEDEC_TYPE?:
I have a SMU connector receptacle for optical fibers.
 
This one is fixed on the board with squares.
I want it in the BOM with also squares.
And of course I want it on the schematic, so I do not want to use callouts 
feature, but maybe there is no other way than this one....
 
#1   ERROR(315) PST file error detected.
No sections found in part 'SMU....
 
Thanks.
 
    William.
 
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
|             Billereau William           |          Tel: (+4122) 76 73403      
     |
|                                                       |                   PCB 
Designer                |
|               CERN TS/DEM             |       william.billereau@xxxxxxx 
<mailto:william.billereau@xxxxxxx>        |
| 1211 Geneve 23 Switzerland  |  Société: AMEC-SPIE/Electrotech |
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=

Other related posts: