[PCB_FORUM] Re: Symbol move and mirror in free view

Use,
Place >> Manually 
Then pick each placed component you would like to re-position and you
can mirror and rotate it while you are moving it. If I remember right,
there was some function you can't perform during this method that you
can do while you are using the MOVE command, but I can't remember
specifically what it was.
Give thanks to Debbie....something. She proffered this little tidbit
last  year sometime. Thanx again Deb.
Good luck.

Jim S. Wages / SR. PCB Layout Designer:  
Cary, NC - H: 919-466-1596 Cell: 919-484-2963
 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Sam Hung
Sent: Tuesday, October 03, 2006 3:14 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Symbol move and mirror in free view

Hello all

Is there away to creat a script ( or some one have a script) to move and

mirror symbol around in viewer.

TIA

Sam

_________________________________________________________________
Find a local pizza place, music store, museum and more.then map the best

route!  http://local.live.com

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: