[PCB_FORUM] Swappable pins within and between resistor packs

Allegro 15.7 with Orcad input;

Does anyone have the device file line statement(s) or Orcad
directive/property that allow pins to be swappable within and between
resistor packs?

 

8 pin resistor package. Pins 1 & 8 are power or ground. The remaining 6 pins
are individual resistors pulled up or down to one of the two pwr/gnd pins I
have several of these packages terminating a memory circuit. 

Does anyone have the Orcad entry or the syntax to change the pstchip.dat
file, that I can later back-annotate to the schematic that will allow me to
swap pins within the package and/or swap individual pins between packages?

 

I used to perform this task quite easily, but do not have one of the designs
which this was performed upon.

Thank you in advance.

 

Jim Wages

SR PCB Layout Designer

Raleigh, NC

Other related posts: