[PCB_FORUM] Re: Speeding up Allegro

Check that autosilk is off for all categories, "manufacture" 'silkscreen' tabs. 
Disable dynamic shape fill.
 
Start turning DRC's off, design constraint one first, then ECset ones.
 
Best Regards
 
David Greig
______________________________
GigaDyne Ltd
5 Albany Business Centre
Gardeners Street
Dunfermline KY12 0RN
United Kingdom
t: +44 (0)1383 624 975
www.gigadyne.co.uk <http://www.gigadyne.co.uk/> 
______________________________
 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx 
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of J Wages
Sent: 16 February 2007 15:00
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Speeding up Allegro



Hi folks,

Quick question and I'm pretty sure I've seen this subject floating around 
before. Allegro 15.5.1

I'm nearing the end of routing a very large and dense design. I'm down to 
cleaning up the power signals (3.3v & gnd.etc) and
Allegro is draggin' big time. What is the easiest way to reduce the time 
between mouse clicks when hooking up these large pin
count nets? Currently is about 20 seconds minimum between clicks.

Change the shapes from dynamic to static? I've turned off the on-line DRC, but 
that didn't seem to help. I know it's probably
something really obvious, but my brain has turned to mush these last couple 
days.

Thanx in advance.

 

Jim S. Wages / SR. PCB Layout Designer:  

Cary, NC - H: 919-466-1596 Cell: 919-484-2963


-- 

Virus scanned by Lumison.

----------------------------------------------------------- To 
subscribe/unsubscribe: Send a message to
icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe 
To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an 
email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: