[PCB_FORUM] Re: Speeding up Allegro

Jim, sometimes I just quit Allegro then come back and it moves a little
faster.
But not all the times.
 
Julian

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of J Wages
Sent: Friday, February 16, 2007 7:00 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Speeding up Allegro



Hi folks,

Quick question and I'm pretty sure I've seen this subject floating
around before. Allegro 15.5.1

I'm nearing the end of routing a very large and dense design. I'm down
to cleaning up the power signals (3.3v & gnd...etc) and Allegro is
draggin' big time. What is the easiest way to reduce the time between
mouse clicks when hooking up these large pin count nets? Currently is
about 20 seconds minimum between clicks.

Change the shapes from dynamic to static? I've turned off the on-line
DRC, but that didn't seem to help. I know it's probably something really
obvious, but my brain has turned to mush these last couple days.

Thanx in advance.

 

Jim S. Wages / SR. PCB Layout Designer:  

Cary, NC - H: 919-466-1596 Cell: 919-484-2963

----------------------------------------------------------- To
subscribe/unsubscribe: Send a message to
icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or
unsubscribe To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: