[PCB_FORUM] Re: Specctra (Router) variables

Thanks, Hugh.
 
Any idea on how to get the number of 'Fails' ?  
 
Cheers,
Richard

>>> hugh@xxxxxxxxxxxxx 14/12/2005 6:55 p.m. >>>

Hi Richard:
 
 The system variables as found in the Specctra  Language discriptor manual. 
 
 
Hugh Allen
Specctra Specialist
CopperCad Design Inc.
www.coppercad.com
hugh@xxxxxxxxxxxxx
 
 
 
<system_variable> <system_variable>::= 
[bottom_layer_sel | complete_wire | conflict_clearance | conflict_crossing |
conflict_length | conflict_wire | conflict_xtalk | connections | current_wire |
locked_comp | partial_selection | power_layers | reduction_ratio |
reroute_wire | route_pass | sel_signal_layers | selectedcomp | signal_layers |
smd_pins | thru_pins | top_layer_sel | total_pass | total_pins | totalcomp |
unconnect_wire | units | unplaced_comp | unplaced_large | unplaced_small] 
The following table shows system variable definitions. 
snip xxx snip
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx 
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of richard moffat
Sent: Tuesday, December 13, 2005 11:31 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Specctra (Router) variables


Hi all
 
I'm writing a .do file for Specctra, and would like to add a few conditions to 
the coding.  
 
I need to know what variables are available.  I know of  "conflict_crossing" 
and "unconnect_wire" - what are any others?
 
Much thanks in advance,
 
Richard
 

__________________________
Richard Moffat
PCB CAD Manager
Allied Telesyn Research Ltd, NZ.
ph. +64 (3) 3393000
richard.moffat@xxxxxxxxxxxxxxxxxxx

NOTICE: This message contains privileged and confidential
information intended only for the use of the addressee
named above. If you are not the intended recipient of
this message you are hereby notified that you must not
disseminate, copy or take any action in reliance on it.
If you have received this message in error please
notify Allied Telesyn Research Ltd immediately.
Any views expressed in this message are those of the
individual sender, except where the sender has the
authority to issue and specifically states them to
be the views of Allied Telesyn Research. 


NOTICE: This message contains privileged and confidential
information intended only for the use of the addressee
named above. If you are not the intended recipient of
this message you are hereby notified that you must not
disseminate, copy or take any action in reliance on it.
If you have received this message in error please
notify Allied Telesyn Research Ltd immediately.
Any views expressed in this message are those of the
individual sender, except where the sender has the
authority to issue and specifically states them to
be the views of Allied Telesyn Research.

Other related posts: