[PCB_FORUM] Re: Slide and little segments...

Hi Gary,

Kidding or not, I KNOW I'm being high maintenance right now.  I have no
problem with that ;-)  I'm using a lot of new features that I haven't used
before on my own, so I'm expecting to bump my head quite a bit.

Regards,

Austin
  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Macindoe, Gary
  Sent: Friday, August 22, 2008 2:14 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: Slide and little segments...


  Hey Austin,



  You're very welcome, you know I'm just kidding about the high maintenance!



  Some days you just have to bang your head a little bit more than others.

  A lot of manual routing and sliding would be one of those days.



  Gary





  Gary E. MacIndoe
  PCB Design Engineer
  Fort Collins, Colorado

  amd.com

  gary.macindoe@xxxxxxx

  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
  Sent: Friday, August 22, 2008 12:09 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: Slide and little segments...



  Hi Gary,



  Oh, and don't think I don't greatly appreciate the help from everyone, I
do!

  I'd even offer to give you a hug, but I think my prolific "thank you"s

  should do, eh?



  Regards,



  Austin



  -----------------------------------------------------------

  To subscribe/unsubscribe:

  Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx

  with a subject of subscribe or unsubscribe



  To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/



  Problems or Questions:

  Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

  -----------------------------------------------------------

GIF image

Other related posts: