[PCB_FORUM] Re: Slide and little segments...

You can try route/custom smooth that should take out the odd little
bits. But if you have a specific delay associated with the net I would
not do it this way. 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Friday, August 22, 2008 1:04 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Slide and little segments...

Hi,

I am trying to slide a lot of lines.  Some slide perfectly, others slide
as one line (as they should), but for a short distance, then I pick them
again, and slide them a bit more etc.  Then there are the ones that make
me want to scream.  They slide only a little short segment at a time,
and miter to the rest of the line...and if I slide that miter to the
end, it removes it, and then I can slide more of the line.  If I spend
the couple of minutes to move the line see the miter and move it to the
end, the line eventually becomes "whole" and operates perfectly.  What
I've decided to do in those cases, is just do another add-connect, and
that makes them "whole" again.

My question is, how do those aggravating little nudges in some lines get
there in the first place, and is there a way to easily remove them?

Regards,

Austin

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: