[PCB_FORUM] Re: Slide and little segments...

Hey Austin,

 

Figuring out all of the little things involved with all of the functions
takes years of use.

Then sometimes Cadence mixes things up so good that you almost have to
start all over again!

 

Anyhow, your Maintenance Agreement is good here.

 

It's when people replace formal training with bugging this forum on the
most basic of questions that I tune out.

 

I'm sure if some of us have the time, we'll continue to get you through
your new "features" (some are bugs you have to work through!).

 

Gary

 

  

Gary E. MacIndoe
PCB Design Engineer
Fort Collins, Colorado

amd.com

gary.macindoe@xxxxxxx

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Friday, August 22, 2008 1:11 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Slide and little segments...

 

Hi Gary,

 

Kidding or not, I KNOW I'm being high maintenance right now.  I have no
problem with that ;-)  I'm using a lot of new features that I haven't
used before on my own, so I'm expecting to bump my head quite a bit.

 

Regards,

 

Austin

        -----Original Message-----
        From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Macindoe, Gary
        Sent: Friday, August 22, 2008 2:14 PM
        To: icu-pcb-forum@xxxxxxxxxxxxx
        Subject: [PCB_FORUM] Re: Slide and little segments...

        Hey Austin,

         

        You're very welcome, you know I'm just kidding about the high
maintenance!

         

        Some days you just have to bang your head a little bit more than
others.

        A lot of manual routing and sliding would be one of those days.

         

        Gary

         

         

        Gary E. MacIndoe
        PCB Design Engineer
        Fort Collins, Colorado

        amd.com

        gary.macindoe@xxxxxxx

        -----Original Message-----
        From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
        Sent: Friday, August 22, 2008 12:09 PM
        To: icu-pcb-forum@xxxxxxxxxxxxx
        Subject: [PCB_FORUM] Re: Slide and little segments...

         

        Hi Gary,

         

        Oh, and don't think I don't greatly appreciate the help from
everyone, I do!

        I'd even offer to give you a hug, but I think my prolific "thank
you"s

        should do, eh?

         

        Regards,

         

        Austin

         

        -----------------------------------------------------------

        To subscribe/unsubscribe: 

        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx

        with a subject of subscribe or unsubscribe

         

        To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

         

        Problems or Questions:

        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

        -----------------------------------------------------------

GIF image

Other related posts: