[PCB_FORUM] Setting origin to a pin location...

Hi,

Is there a way to set (aside from typing in numbers I get from "info") the
origin to be a specific "object" (like the intersection of two lines for the
lower left corner of the board, or the exact location of a pin)?  I want to
set the origin to a pin on a metric device so I can do placement relative to
that device, then set it back to the lower left corner of the board.

Regards,

Austin


-----------------------------------------------------------
To subscribe/unsubscribe: 
        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
        with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  
Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

Other related posts: