[PCB_FORUM] Re: "Scrubbing" rules/bus/matchgroup in Allegro Constraint Manager...

Hi Tony,

Just the opposite...I want the info in the $PROPERTIES to be used, and all
the existing info in the .brd file to be "scrubbed".

Regards,

Austin
  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Tony Stanislao
  Sent: Monday, May 11, 2009 8:40 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: "Scrubbing" rules/bus/matchgroup in Allegro
Constraint Manager...


  If you create a .tel file you could delete the $Properties section.
    ----- Original Message -----
    From: Austin Franklin
    To: icu-pcb-forum@xxxxxxxxxxxxx
    Sent: Monday, May 11, 2009 12:35 PM
    Subject: [PCB_FORUM] "Scrubbing" rules/bus/matchgroup in Allegro
Constraint Manager...


    Hi,

    I have my busses, matchgroups, ecset references and diff pairs defined
in my
    schematics.   In order to read in new information in the netlist, I need
to
    delete the old info manually for these in the constraint manager.  Is
there
    an easy way to do this aside from selecting them and hitting "delete"?

    Thanks,

    Austin

    -----------------------------------------------------------
    To subscribe/unsubscribe:
    Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
    with a subject of subscribe or unsubscribe

    To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

    Problems or Questions:
    Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
    -----------------------------------------------------------

Other related posts: