[PCB_FORUM] Re: SPB16.2 - Can't change impedance value in Cross section menu
- From: "Bill Dempsey" <bdempsey85@xxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Wed, 7 Jan 2009 13:29:29 -0600
I have seen this too and reported it back to Cadence. You might want to
submit a SR on this as well.
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Crittenden, Mike
Sent: Wednesday, January 07, 2009 12:24 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] SPB16.2 - Can't change impedance value in Cross section
menu
Hello All,
Just upgraded to 16.2 and when I try to chance the impedance value in
the cross section menu, it is stuck on 60 ohms. Any suggestions?
Thanks!
Mike Crittenden
Technology Services Corporation, Phase IV Operation
(256) 535-2118
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
Other related posts: