[PCB_FORUM] SPB16.2 - Can't change impedance value in Cross section menu

Hello All,

Just upgraded to 16.2 and when I try to chance the impedance value in
the cross section menu, it is stuck on 60 ohms.  Any suggestions?

Thanks!

Mike Crittenden
Technology Services Corporation, Phase IV Operation
(256) 535-2118


-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: