[PCB_FORUM] Re: Questions regarding Xnet.

Hi Seiji,

Yes, you can create XNets in Allegro PCB.  What level of Allegro PCB do you
have?

Regards,

Austin
  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of arimitsu seiji
  Sent: Friday, February 23, 2007 7:05 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Questions regarding Xnet.


  Hello everyone!

  I was looking into setting up Xnets for some differential pairs/bus
routing.  I printed out some documents from Cadence, but it only gave
instructions for Design Entry HDL.  I was wondering if it was possible to
create Xnet property through just Allegro PCB design rather than using
Design entry HDL and if so is there any guidelines available anywhere?  Also
if not I am not very familiar with Design Entry HDL so I will have to mess
it for a while :(  Anyhow, thank you all for reading and replying.  Have a
great weekend.

  Seiji

  ----------------------------------------------------------- To
subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe To view the archives of this list
go to http://www.freelists.org/archives/icu-pcb-forum/ Problems or
Questions: Send an email to
icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------
------------------

Other related posts: