[PCB_FORUM] Questions regarding Xnet.

Hello everyone! 

I was looking into setting up Xnets for some differential pairs/bus routing.  I printed out some documents from Cadence, but it only gave instructions for Design Entry HDL.  I was wondering if it was possible to create Xnet property through just Allegro PCB design rather than using Design entry HDL and if so is there any guidelines available anywhere?  Also if not I am not very familiar with Design Entry HDL so I will have to mess it for a while :(  Anyhow, thank you all for reading and replying.  Have a great weekend.

Seiji

----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------

Other related posts: