Thank you. This worked the best for me. For some reason going to Tools -> options-> General->set PATH property invisible didn't do the trick. Garrett Gilbertson "Ritter, Alan" <Alan.Ritter@xxxxxxxxxx> Sent by: icu-pcb-forum-bounce@xxxxxxxxxxxxx 04/13/2005 05:35 AM Please respond to icu-pcb-forum To: icu-pcb-forum@xxxxxxxxxxxxx cc: Subject: [PCB_FORUM] Re: Property PATH question From the Concept command line, type: Find PATH (Concept will respond with a group letter A-Z) Display invisible A (substitute the group number for 'A') (Or just "Dis inv A" for those of us who remember abbreviations better?) /s/jar (alan.ritter@xxxxxxxxxx) http://www.mtritter.org From: Garrett Gilbertson [mailto:Garrett.Gilbertson@xxxxxxx] Sent: Tuesday, April 12, 2005 10:51 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Property PATH question Cadence 15.2 on Windows: Concept HDL question: Can someone tell me how to turn off the property PATH that is showing in concept? Thank you. Garrett Gilbertson EMAIL DISCLAIMER Please Note: The information contained in this message may be privileged and confidential, protected from disclosure, and/or intended only for the use of the individual or entity named above. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any disclosure, distribution, copying or other dissemination of this communication is strictly prohibited. If you received this communication in error, please immediately reply to the sender, delete the message and destroy all copies of it. Thank You