[PCB_FORUM] Re: PPT Query

I don't understand why you have this problem. When I select the line
entry in the ppt file the part is automatically on my cursor when I move
it.

I am just a Librarian but use Concept a lot to test my parts. I am still
running v15.2 but am due to update by EOY. There is a check box in
TOOLS>Options called Show PPT Browser. When this is selected, the ppt
automatically opens when a part is selected.

Possibly there is a setup somewhere that I have selected. But then again
if you guys are running a newer version; maybe the tool was changed to
"not help".
Shirley in Oregon


-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Peter Hughes
Sent: Tuesday, November 28, 2006 2:51 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] PPT Query

Hi All,

I want to pick a pack type in a part table and automatically the
specified version is attached to my cursor. Is there any way of doing
this in Concept.

Rgrds
 
Peter Hughes,
PCB Designer,
Concurrent Technologies,
4 Gilberd Close,
Newcomen Way,
Colchester,
Essex,
CO4 4WN.
Tel: +44 1206 752626
Fax: +44 1206 751116
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: