[PCB_FORUM] Odd fill problem, different gerber styles work...

Very simple board...  small, 4 layers.  Using 15.2
 
Fill is on, and is dynamic.  With the Global parameters set to Gerber 4x00, the 
fill and voids show up and the fill fills.  Works fine.
 
Change the Global parameters to Gerber 6x00 and the fill works fine, the 
boundry is visible and all is well.  
 
Change to 274X and the fill, only on the top layer, suddenly goes away.  (the 
other layers work fine)  The boundry data is still present, I can see the 
outlines and the voids, but there is now no fill.  Worst yet, now, when I go to 
artwork parameters...  I am prompted to update the fill...  which does nothing, 
it reports just fine, it just is not there.  And of course I cannot go on as 
the artwork says fill needs to be updated.  
 
Fill fails for anything except Gerber 4x00 or 6x00.  
 
Anybody have a clue as to what the key might be here?  Strange one I tell ya.  
Very strange.

Other related posts: