[PCB_FORUM] Re: No text or lines showing up in Gerbers...solved...

It is an undefined width problem, but you have to set it for EACH drawing.
You can't just select them all, and set it.

Regards,

Austin
  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Austin Franklin
  Sent: Thursday, June 04, 2009 3:36 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: No text or lines showing up in Gerbers...


  Nope...setting undefined line width to 4 didn't do it.
    -----Original Message-----
    From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Austin Franklin
    Sent: Thursday, June 04, 2009 3:33 PM
    To: icu-pcb-forum@xxxxxxxxxxxxx
    Subject: [PCB_FORUM] Re: No text or lines showing up in Gerbers...


    Undefined line width...  Why the identical text in one shows up and not
in the other two...I have no clue...yet.

      -----Original Message-----
      From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Austin Franklin
      Sent: Thursday, June 04, 2009 3:24 PM
      To: icu-pcb-forum@xxxxxxxxxxxxx
      Subject: [PCB_FORUM] No text or lines showing up in Gerbers...


      Hi,

      When I bring go to the manufacturing/artwork tab, and select, say,
fabrication drawing and display to make the display look like what the
Gerber should look like, it looks fine.  I print it out, and everything is
great.  But, when the Gerbers get generated, ALL text and lines are gone!
Etch is fine...

      What is going on here?

      Thanks,

      Austin

Other related posts: