[PCB_FORUM] Re: No text or lines showing up in Gerbers...

Hi Gerry,

Yep, found that on my own.  Then found it has to be set for EVERY one, even
if all them are checked.  I should have known that, given reading the file
into GerbTool gave me a zero error.  I should have done two minutes of
looking before asking the list, but the good news, is every reply was right
;-)

Regards,

Austin
  -----Original Message-----
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Gerry Meier
  Sent: Thursday, June 04, 2009 3:38 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: No text or lines showing up in Gerbers...




  Gerry Meier, Sr. PCB Designer
  Freedom CAD Services. Inc
  Voice: (256) 776-7470 or (603) 864-1350
  Email:gerry.meier@xxxxxxxxxxxxxx
  visit us at http://www.freedomcad.com






----------------------------------------------------------------------------
--
  From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
  Sent: Thursday, June 04, 2009 2:33 PM
  To: icu-pcb-forum@xxxxxxxxxxxxx
  Subject: [PCB_FORUM] Re: No text or lines showing up in Gerbers...


  Undefined line width...  Why the identical text in one shows up and not in
the other two...I have no clue...yet.

    -----Original Message-----
    From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Austin Franklin
    Sent: Thursday, June 04, 2009 3:24 PM
    To: icu-pcb-forum@xxxxxxxxxxxxx
    Subject: [PCB_FORUM] No text or lines showing up in Gerbers...


    Hi,

    When I bring go to the manufacturing/artwork tab, and select, say,
fabrication drawing and display to make the display look like what the
Gerber should look like, it looks fine.  I print it out, and everything is
great.  But, when the Gerbers get generated, ALL text and lines are gone!
Etch is fine...

    What is going on here?

    Thanks,

    Austin


  This correspondence and any attachments are considered confidential. If
you are not the intended recipient, please notify Freedom CAD Services, Inc.
immediately by either replying to this message or by sending an email to
operations@xxxxxxxxxxxxxx; please destroy all copies of this message and any
attachments. Thank you.

JPEG image

Other related posts: