[PCB_FORUM] Re: No text or lines showing up in Gerbers...

Austin,
 
If you add a photoplot width to your all your text you won't
need to change the Gerber setup. The width can vary for the text size
too.
 
Jerry 
 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Thursday, June 04, 2009 4:46 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: No text or lines showing up in Gerbers...


Hi Gerry,
 
Yep, found that on my own.  Then found it has to be set for EVERY one,
even if all them are checked.  I should have known that, given reading
the file into GerbTool gave me a zero error.  I should have done two
minutes of looking before asking the list, but the good news, is every
reply was right ;-)
 
Regards,
 
Austin
        -----Original Message-----
        From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Gerry Meier
        Sent: Thursday, June 04, 2009 3:38 PM
        To: icu-pcb-forum@xxxxxxxxxxxxx
        Subject: [PCB_FORUM] Re: No text or lines showing up in
Gerbers...
        
        
         
         
        Gerry Meier, Sr. PCB Designer
        Freedom CAD Services. Inc
        Voice: (256) 776-7470 or (603) 864-1350
        Email:gerry.meier@xxxxxxxxxxxxxx
        visit us at http://www.freedomcad.com
         
         
         

________________________________

        From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
        Sent: Thursday, June 04, 2009 2:33 PM
        To: icu-pcb-forum@xxxxxxxxxxxxx
        Subject: [PCB_FORUM] Re: No text or lines showing up in
Gerbers...
        
        
        Undefined line width...  Why the identical text in one shows up
and not in the other two...I have no clue...yet.
         
                -----Original Message-----
                From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of Austin Franklin
                Sent: Thursday, June 04, 2009 3:24 PM
                To: icu-pcb-forum@xxxxxxxxxxxxx
                Subject: [PCB_FORUM] No text or lines showing up in
Gerbers...
                
                
                Hi,
                 
                When I bring go to the manufacturing/artwork tab, and
select, say, fabrication drawing and display to make the display look
like what the Gerber should look like, it looks fine.  I print it out,
and everything is great.  But, when the Gerbers get generated, ALL text
and lines are gone!  Etch is fine...
                 
                What is going on here?
                 
                Thanks,
                 
                Austin
                 

        This correspondence and any attachments are considered
confidential. If you are not the intended recipient, please notify
Freedom CAD Services, Inc. immediately by either replying to this
message or by sending an email to operations@xxxxxxxxxxxxxx; please
destroy all copies of this message and any attachments. Thank you.

JPEG image

Other related posts: