[PCB_FORUM] Re: Move component with unwanted traces

Is there a way to block the auto replies that 14 people are "out of the office"?
I get them whenever I post a question.
Well...here we go again.

Thanks,
Mark

Mark Salberg wrote:

Hello all,
When we move a component...with or without "stretch" selected. Some traces and vias move with it.
We have run DBFIX but still repeats. Now we need to delete the trace, move the part, then re-route. :-(

Only happens on some components...not all.

Any suggestions?
Thanks,
Mark


_____________________________________________________________________________

Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________

-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

_____________________________________________________________________________

Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________




_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________
-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: