[PCB_FORUM] Re: Max Parallelism not forcing spacing requirements. Only gives a DRC.

David,

I was not referring to Auto routing but interactive and I  do not  remember it 
shoving due to parallelism rules.

Excuse me if my memory is fading,
Gerry

Gerry Meier, Sr. PCB Designer
Freedom CAD Services. Inc
Voice: (603) 864-1350 ** NEW**
Cell: (256) 714-2791
Email:gerry.meier@xxxxxxxxxxxxxx
Skype: rgmeier3
visit us at http://www.freedomcad.com<http://www.freedomcad.com/>
 P  Think Green only print as needed.

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx 
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of David Price
Sent: Friday, March 16, 2012 1:02 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Max Parallelism not forcing spacing requirements. Only 
gives a DRC.

The Router enforces parallelism perfectly.

David

At 01:53 PM 3/16/2012, you wrote:

Mark,

It has never worked that way neither has PCB Router - to get that you need to 
assign spacing rules

Gerry Meier, Sr. PCB Designer
Freedom CAD Services. Inc
Voice: (603) 864-1350 ** NEW**
Cell: (256) 714-2791
Email:gerry.meier@xxxxxxxxxxxxxx
Skype: rgmeier3
visit us at http://www.freedomcad.com<http://www.freedomcad.com/>
 P  Think Green only print as needed.

From: 
icu-pcb-forum-bounce@xxxxxxxxxxxxx<mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx> [ 
mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg
Sent: Friday, March 16, 2012 11:45 AM
To: icu-pcb-forum@xxxxxxxxxxxxx<mailto:icu-pcb-forum@xxxxxxxxxxxxx>
Subject: [PCB_FORUM] Max Parallelism not forcing spacing requirements. Only 
gives a DRC.

Max Parallelism not forcing spacing requirements. Only gives a DRC.

I have max Parallelism rules set as below.
When I slide these traces together, it will report a DRC, but I would like it 
NOT to allow me to slide too close together.
[[]]
How can I set Allegro to NOT allow these traces too close together. During 
slide, I have Allowed DRC left UNCHECKED.
[[]]

Thanks in advance,
Mark

PNG image

PNG image

Other related posts: