[PCB_FORUM] Re: Low on available memory, please exit the program.

  • From: ricmar@xxxxxxxxxxx
  • To: icu-pcb-forum@xxxxxxxxxxxxx, icu-pcb-forum@xxxxxxxxxxxxx, "Walter Boese Jr." <walterb@xxxxxxx>
  • Date: Fri, 22 Feb 2008 16:45:17 +0000

I have been informed XP will run 4 GIG but reports it incorrectly as 3 GIG.

I have it on my other site and a 3RD Party Utility (Avanquest) reports it as 4 
GIG.

Richard E Marion

-------------- Original message -------------- 
From: "Walter Boese Jr." <walterb@xxxxxxx> 

> Not that this is your problem, but for info purposes. 
> Windows XP cannot address 4gig of memory. 
> There is a 3gig switch, but we have found that to be problematic. 
> 
> The only way to address 4gig is with Windows XP Pro 64bit and Cadence 
> does not support 64bit Windows at this time. 
> 
> Walter Boese Jr. 
> SGI 
> 
> 
> Julian Ungureanu (jungurea) wrote: 
> > 
> > I thought I post this here before I open a case with Cadence. 
> > I get this message when updating DRCs. 
> > The brd file is ~100 Mb. 
> > T61P, 2.2 GHz, 4 Gb RAM, Windoze XP 
> > Any ideas why? 
> > 
> > 
> > Thanks, 
> > Julian U. 
> > 
> > 
> 
> -- 
> 
> 
> Walter Boese, Jr. 
> walterb@xxxxxxx 
> 
> ----------------------------------------------------------- 
> To subscribe/unsubscribe: 
> Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
> with a subject of subscribe or unsubscribe 
> 
> To view the archives of this list go to 
> //www.freelists.org/archives/icu-pcb-forum/ 
> 
> Problems or Questions: 
> Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx 
> -----------------------------------------------------------

Other related posts:

  1. Home
  2. icu-pcb-forum
  3. Archive
  4. 02-2008