[PCB_FORUM] Logic synchronization failed during "update symbols" in Allegro

Dear All,

In conceptdhl we're using one block which is repeated several times. We
use this module in allegro to ease the layout.

The steps we take in order to create the module are:
1 - in project manager setup we choose the "Design Name" of the block
which will be copied several times, lets call it "TOP_BOTTOM_ANALOG".

2 - Open the "Design Entry" and create the desired schematics

3 - Then "Package Design" and create the layout of that specific block,
lets call it "TOP_BOTTOM_ANALOG".

4 - in Allegro we create the module and call it top_bottom_analog.mdd"

5 - In "Export Physical" "Advanced" "Subdesign" I add the name
"TOP_BOTTOM_ANALOG" in the "Generate Subdesign" and package the design
again.

6 - then select project manager's setup and select our TOP design, where
several copies of "TOP_BOTTOM_ANALOG" are present.

7 - In "Export Physical" "Advanced" "Subdesign" I add the name
"multi_block" in the "force Subdesign" and package the entire design.

At this point we had already done several "export Physical", and during
this process everything does fine.

8 - But now when we "update symbols" we get several warnings which we
cannot understand.

------ Module Refresh Messages ------

Updating module 'TOP_BOTTOM_ANALOG' instance 'TOP_BOTTOM_ANALOG_1'.
Updating module 'TOP_BOTTOM_ANALOG' instance 'TOP_BOTTOM_ANALOG_1'.
WARNING: Component not found for symbol C0603 at (3048.89 3235.91),
reuse id 1~
6.
WARNING: Logic synchronization failed. Continuing.
WARNING: Component not found for symbol PQFP80_050_EP at (3538.63
3386.58), re~
use id 17.
WARNING: Logic synchronization failed. Continuing.
WARNING: Component not found for symbol PQFP80_050_EP at (3011.02
3386.62), re~
use id 14.
WARNING: Logic synchronization failed. Continuing.
WARNING: Component C75_1 is already placed. Using existing component
placement
WARNING: for symbol C0402 at (3356.14 3952.73).
update successful.




The components are already placed within the module but we don't fully
understand "Logic synchronization failed. Continuing." message really
means. I've tried googling and on Allegro's documentation and nothing.


Does anyone know what does this mean and how to sort it out?


Thanks in advance.

Best regards,
Rui
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: