[PCB_FORUM] Re: Is there a way to step and repeat placement for identical circuits on the same PCB?

Franklin,
do you tried to move clines and vias with ix 0 0 increment? This way allegro assign clines to right nets. Maybe some components are not at the proper place, so you have to complete components swap.. One other thing: do you have planes on others layers? Vias try to attach to planes when copied.... I but planes offboard then move ix 0 0 vias to, reconect to right signals. Then back planes in board. 
Maybe a dbdoctor can also help...

Regards,

Jean-Charles

Austin Franklin a écrit :

Hi Jean-Charles,


- As you say, routing can be copied. Symbols can be also copied.


Well, I can copy the routing...but I get DRC errors when I drop it on the
other components "top line to SMD pin spacing".  The two components I am
copying the routing from/to are on the same grid.  If I route directly from
the pins of the 2nd component, the routing is fine.  What seems to be
happening, is the clines aren't taking on the net names that the pins are
assigned to.  What am I doing wrong?  I know I've done this before with no
problem.  I'm using 15.7.

Regards,

Austin
-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------



-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: