[PCB_FORUM] Re: Intelligent Dual Footprints 15.x

Yes it is, but it only works with Concept and Capture.

 

  _____  

From: george.h.patrick@xxxxxxxxxxxxxx
[mailto:george.h.patrick@xxxxxxxxxxxxxx] 
Sent: Wednesday, September 29, 2004 11:33 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Intelligent Dual Footprints 15.x

 

 

This is a perfect use for a module.

 

I don't know if you can do this without Concept-HDL, though.

 

-- 
George Patrick
Tektronix, Inc.
Central Engineering, PCB Design Group
P.O. Box 500, M/S 39-512
Beaverton, OR 97077-0001
Phone: 503-627-5272         Fax: 503-627-5587 <http://www.tektronix.com/> 
http://www.tektronix.com     <http://www.pcb-designer.com/>
http://www.pcb-designer.com

It's my opinion, not Tektronix' 

-----Original Message-----
From: Design1955@xxxxxxxxxxx [mailto:design1955@xxxxxxxxxxx] 
Sent: Tuesday, September 28, 2004 17:23
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Intelligent Dual Footprints 15.x

I have been asked to create a footprint containing the following
information:

A bga containing all of it's fan-out recommended by the spec.

all of it's supporting decoupling caps, connected per the EE's rules.

So every time I place this component it will have the particular BGA and
the supporting caps placed and also routed to the power and ground pins per
the schematic. 

I am using 15.2 and VueLogic front end.

Does anyone know if there is a way to make this work as a complete
intelligent footprint you placing it as a block of components with routing?

Thanks

Steve

Other related posts: