[PCB_FORUM] Importing non-allegro 274x gerbers into allegro

Hi Everyone,
We are trying to import rs274x gerbers from another tool into allegro.
However, we are having issues doing so. Firstly we are unable to load them
as 274x at all ( allegro aborts the load). So we have created an aperture
list and tried to import them as gerber 4 or 6 but then they come in on the
wrong scale. We have already tried re-outputting the rs274x from valor but
that does not work either. Any ideas? We would prefer to get them in as 274x
first shot but knowing that allegro doesn't always play nice with others is
there a way to scale them?
Thanks in advance,
Dharma


KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.



-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: