[PCB_FORUM] Re: IDF import to PROE

Hi all,

Yes, it is in continuous line. This BRD use to be able to be imported into
the PROE. But after numerous changes on the schematic, I want to do a final
check on the placement but Mechanical just could not import in the emp/emn
files.

Puzzle??

Best regards,
Eileen

 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
dalocke2@xxxxxxxxxxx
Sent: Thursday, September 28, 2006 10:46 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: IDF import to PROE

Make sure the board outline is one continous line.  ProE will not work if it
is in segments.



 -------------- Original message ----------------------
From: "Eileen Ong" <eileen.ong@xxxxxxxxxxxxxx>
> Hi all,
> 
>  
> 
> I have generated a IDF file for PROE to import to check on the placement.
> Problem is the mechanical is able to import the emn/emp files for IDF
> generated from one of the BRD file but on another BRD file.The mechanical
> can't open the emn/emp files. It always prompt  them to correct part
> geometry with Sketcher. Any one got any clue how to resolve this?
> 
>  
> 
> 
> 
>  
> 
> Thanks in advance for help.
> 
> Best regards,
> Eileen 
> 




-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: