Hi Matija Thx a lot. Regards Malou On 2/11/12, Matija Golar <matija@xxxxxxxxx> wrote: > in find tab select Property in pulldown and click more, > there you have listed > bus_name=data_bus > bus_name=address_bus > and many others...... > > i think it might be dependant on that project needs to have constraint > flow enabled > (if there are no entries under properties...) > > this answers both your questions ;) > > just make sure you enable net on find tab before clicking more becouse > nets carry properties of bus > > > regards, > Matija > > > > On 11.2.2012 13:29, malou teoxon wrote: >> Good day allegro expert >> 1. Just wanna ask how to delete the whole bus signals in allegro? >> For ex. I need to delete the whole address bus in my layout, May I >> know how to delete them by bus and not by selection one by one . >> 2 If we want to subdarwing a certain bus signals ex address and data >> bus, How to subdrawing the whole bus signals without selecting them >> one by one ? >> Thank you very much >> Regards >> MAlou > > ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------