[PCB_FORUM] Re: How do I include .dra file that contains my board outline in a DxD schematic?

As far as I know, as long as the schematic symbol or part table references
your .dra file, matches the pin numbering and pin count of your Allegro
symbol, and is available in your library path, you should not have a
problem.

Jim S. Wages
SR PCB Layout Designer
H) 919-237-3915 C) 919-484-2963

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Sunday, April 26, 2009 1:34 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] How do I include .dra file that contains my board
outline in a DxD schematic?

Hi,

I have a schematic symbol for this board outline.  PCB forward generates a
device file.  I also have a .dra/.psm file of the board outline.  What do I
need to setup in the schematic symbol to get it to read in the board outline
file when I import the DxDesignser netlist into Allegro?

Regards,

Austin

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: