[PCB_FORUM] Re: Gerbers to placement file

Hi George,
Another good suggestion..... That last part is a double edged sword though
Too much time = no money! :-)
Dharma
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.

 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
george.h.patrick@xxxxxxxxxxxxxx
Sent: Friday, July 13, 2007 12:50 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Gerbers to placement file


 
Only way I have seen this done in the past is to:

*       Import the gerbers with the pad targets on. 

*       Create packages that correspond to the pad and silkscreen locations
(or use existing packages), using the BOM if you have one. 

*       Substitute the packages where they belong 

*       Extract the placement.

Rather time consuming, but time is money :)
 
-- 
George Patrick
Tektronix, Inc.
Central Engineering, EDS Applications Support
P.O. Box 500, M/S 39-512
Beaverton, OR 97077-0001
* 503-627-5272 (voice)     * 503-627-5587 (fax) <http://www.tektronix.com/> 
http://www.tektronix.com     <http://www.pcb-designer.com/>
http://www.pcb-designer.com
 
"Off-Grid and Proud of it!"

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dharma Kemp-Bresett
Sent: Friday, July 13, 2007 09:16
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Gerbers to placement file


Hi Everyone,
I have an interesting question (which I will be posting on a couple of
forums so some of you may see this more than once)....
If all I have is gerbers can I make a placement file from them? I don't need
a netlist just x - y coordinates... I am hoping someone else here has been
faced with this situation before and can point me in the right direction.
Thanks in advance,
Dharma
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.

Other related posts: