[PCB_FORUM] Re: Gerbers to placement file

 
Only way I have seen this done in the past is to:

*       Import the gerbers with the pad targets on.
*       Create packages that correspond to the pad and silkscreen
locations (or use existing packages), using the BOM if you have one.
*       Substitute the packages where they belong
*       Extract the placement.

Rather time consuming, but time is money :)
 
-- 
George Patrick
Tektronix, Inc.
Central Engineering, EDS Applications Support
P.O. Box 500, M/S 39-512
Beaverton, OR 97077-0001
* 503-627-5272 (voice)     * 503-627-5587 (fax)
<http://www.tektronix.com/> 
http://www.tektronix.com     <http://www.pcb-designer.com/>
http://www.pcb-designer.com
 
"Off-Grid and Proud of it!"

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dharma
Kemp-Bresett
Sent: Friday, July 13, 2007 09:16
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Gerbers to placement file


Hi Everyone,
I have an interesting question (which I will be posting on a couple of
forums so some of you may see this more than once)....
If all I have is gerbers can I make a placement file from them? I don't
need a netlist just x - y coordinates... I am hoping someone else here
has been faced with this situation before and can point me in the right
direction.
Thanks in advance,
Dharma
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents
contain information that is confidential, privileged or exempt from
disclosure under applicable law and is intended for the exclusive use of
the addressee. This information is private and protected by law. If you
are not the intended recipient, or have received this email in error,
you are hereby notified that any disclosure, copying, distribution or
use of the contents of this document in any manner is strictly
prohibited.

Other related posts: