[PCB_FORUM] Re: Fabmaster

Fabmaster was purchased by a company called Technomatix Unicam. I called them 
and got the installation files from them. I believe they are located in 
Portsmouth NH. I think the correct number is 603-431-9411. You can also look 
them up on the web. I hope this helps. Good luck! 

Donna
--- Begin Message --- 
Does anybody have the installation files for Fabmaster? All I have is
the batch file to create the fabmaster file. I have used it to create my
fabmaster file with my $CDSROOT set to PSD_15.1 and SPB_15.2 with no
problems. However, I understand that with the .exe file you can specify
which extracta command to use. I will gladly run a comparison test if I
can obtain the install that will give me the .exe file.

 

Daniel So

1065 La Avenida

Mtn View, Ca 94043

(650) 693-2054

email: danielso@xxxxxxxxxxxxx

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Ed Caldwell
Sent: Tuesday, April 26, 2005 1:31 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Fabmaster

 


I do not have Fabmaster. I am running Allegro under Windows XP. 
I now have a CDC2FAB.exe file that I am trying. It has been running for
ten minutes. : ( 

Thanks,
Ed 

Ed Caldwell
Circuit Board Design Engineer
Electronic Design Services at ARRIS Broadband
Voice: 678 473 5073
Email: ed.caldwell@xxxxxxxxxx 



"Andrew Noonan" <andrew@xxxxxxxxxxx> 
Sent by: icu-pcb-forum-bounce@xxxxxxxxxxxxx 

04/26/2005 04:04 PM 

Please respond to
icu-pcb-forum@xxxxxxxxxxxxx

To

<icu-pcb-forum@xxxxxxxxxxxxx> 

cc

 

Subject

[PCB_FORUM] Re: Fabmaster

 

 

 




Hi Ed, 
Yes, Fabmaster can generate output from 15.2, though the tool must be
slightly reconfigured to look at the 15.2 'extracta.exe file instead of
the 14.2 version. 
Do you have the windows version?  If so, start the program, click
File>Configure and Browse to the Extraction Tool in the 15.2 directory. 
  
Andrew Noonan 
Sr. PCB Designer 
Topspin Communications 
(w)650-316-3398 
(c)650-814-3677 
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Ed Caldwell
Sent: Tuesday, April 26, 2005 12:33 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Fabmaster


Does anyone know if a Fabmaster file can be generated from Allegro 15.2
- EMA says no. 
Thanks,
Ed

--- End Message ---

Other related posts: