[PCB_FORUM] FW: net short

Thanks for all the feedback folks. I really appreciate it. The attached
file which describes using the NET_SHORT property was a solution and
works well, with only one drawback. You can only use a trace to tie two
different nets together. I was hoping to use another shape to short the
nets, but this worked well. Mike Golding was kind enough to pass it on
to me and he said it was ok to pass it on to ya'll. Thanx again... and
good routing!

 

Jim S. Wages / SR. PCB Layout Designer:  

(919) 484-2963

-----Original Message-----
From: Mike Golding [mailto:Mike.Golding@xxxxxxxxxx] 
Sent: Thursday, August 26, 2004 1:30 PM
To: 'jwages@xxxxxxxxx'
Subject: net short

 

got this awhile back, have not tried it out yet. let me know how it
works.

 

Mike Golding                   \  mike.golding@xxxxxxxxxx 
PCB Designer                  \  +1-920-969-6114 Phone 
Plexus Technology Group  \ +1-920-428-3280 Cell 
55 Jewelers Park Drive       \  +1-920-751-5366 Fax 
Neenah, WI  54957             \  www.plexus.com

Other related posts: