[PCB_FORUM] Re: Extracting Drill info

Use the axlDBGetDrillPlating function. 

Regards,
Charlie
321.727.6235

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Peter Hughes
Sent: Thursday, March 22, 2007 11:29 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Extracting Drill info

Hi All,

I want to extract the plating attribute form all padstacks in a design.
Is this possible to do in SKILL without using the extracta command

Rgrds
 
Peter Hughes,
PCB Designer,
Concurrent Technologies,
4 Gilberd Close,
Newcomen Way,
Colchester,
Essex,
CO4 4WN.
Tel: +44 1206 752626
Fax: +44 1206 751116

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: