[PCB_FORUM] Re: Extracting Drill info

Yes, it's easy to do.

You would first select all the holes and then loop through the list of
holes and query the plating status of each hole.

 
Douglas G. Stanley
dstanley@xxxxxxxxxxxx
(949) 926-5889
 
 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Peter Hughes
Sent: Thursday, March 22, 2007 8:29 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Extracting Drill info

Hi All,

I want to extract the plating attribute form all padstacks in a design.
Is this possible to do in SKILL without using the extracta command

Rgrds
 
Peter Hughes,
PCB Designer,
Concurrent Technologies,
4 Gilberd Close,
Newcomen Way,
Colchester,
Essex,
CO4 4WN.
Tel: +44 1206 752626
Fax: +44 1206 751116

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------


-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: