[PCB_FORUM] Re: Exporting Constraints from V16 to V15.5

Is there a procedure for this?  I thought it was deemed nigh on impossible.

>>> "Jim Wages" <jwages@xxxxxxxxx> 29/03/2008 8:55 a.m. >>>
Anyone have any luck importing V16 constraints into a V15.5 board? 

 

Jim S. Wages 
SR. PCB Layout Designer 
(

 


NOTICE: This message contains privileged and confidential
information intended only for the use of the addressee
named above. If you are not the intended recipient of
this message you are hereby notified that you must not
disseminate, copy or take any action in reliance on it.
If you have received this message in error please
notify Allied Telesis Labs Ltd immediately.
Any views expressed in this message are those of the
individual sender, except where the sender has the
authority to issue and specifically states them to
be the views of Allied Telesis Labs.
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: