[PCB_FORUM] Re: Dynamic shape void to Mechanical symbol NPTH

Jim,
 
Look at the pin properties of the  hole - you can add properties to make
the shape void or not void , set the clearances, etc.
 
 
Regards,
Gerry
 
Gerry Meier
Sr. PCB Designer
Freedom CAD Services, Inc.
Voice: (603) 864-1300 x1350
AL Voice: (256) 417-6944
Email: gerry.meier@xxxxxxxxxxxxxx
visit our website at<http://www.freedomcad.com
 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Jim Goshorn
Sent: Monday, December 12, 2005 4:37 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Dynamic shape void to Mechanical symbol NPTH



In 15.2 Studio, I am having a problem with a NPTH to dynamic shape.
The shape is looking at the hole as if it were part of the NO_TYPE group
in a high voltage area on the board where no_type has a large DRC
spacing.
I am not sure how to append or what to append to the mechanical symbol
to reduce the clearance. Has anyone run into this type of situation ?


Jim Goshorn

Other related posts: