[PCB_FORUM] Re: Dynamic shape status report strangeness...

Austin,
Turn on the 'BOUNDARY' layer in the 'stackup' section of color dialog
window. They will probably show up there. Delete those and those should
go away.
Andrew

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Monday, June 15, 2009 7:11 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Dynamic shape status report strangeness...

Hi,

I do a dynamic shape status report and get the following:

Layer = TOP
     State: Smooth       Point on shape: (3906.48 1121.76) Net: VDD_3-3
     State: No Etch      Point on shape: (3808.08 1313.64) Net: Dummy
Net
     State: No Etch      Point on shape: (3808.08 1269.36) Net: Dummy
Net
     State: No Etch      Point on shape: (3867.12 1269.36) Net: Dummy
Net
     State: No Etch      Point on shape: (3857.28 1259.52) Net: Dummy
Net
     State: Smooth       Point on shape: (3808.08 1220.16) Net: VDD_3-3

But, the problem is, there is no shape at the points where it says "No
Etch".  Anyone have any idea how to get rid of these?

I'm on 15.7.

Regards,

Austin
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: