[PCB_FORUM] Dynamic shape status report strangeness...

Hi,

I do a dynamic shape status report and get the following:

Layer = TOP
     State: Smooth       Point on shape: (3906.48 1121.76) Net: VDD_3-3
     State: No Etch      Point on shape: (3808.08 1313.64) Net: Dummy Net
     State: No Etch      Point on shape: (3808.08 1269.36) Net: Dummy Net
     State: No Etch      Point on shape: (3867.12 1269.36) Net: Dummy Net
     State: No Etch      Point on shape: (3857.28 1259.52) Net: Dummy Net
     State: Smooth       Point on shape: (3808.08 1220.16) Net: VDD_3-3

But, the problem is, there is no shape at the points where it says "No
Etch".  Anyone have any idea how to get rid of these?

I'm on 15.7.

Regards,

Austin
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: