Go to Setup > Drawing Options. Check at the bottom to see that Fill Mode is set to Smooth. If not, that's your problem, select smooth and then run drc and you should be good to go. In either case, if you select the colored square next to "Out of date shapes" it should tell you what layer and a coordinate for each. Good luck! Jean ________________________________ From: Kipnis, Oleg [mailto:Oleg.Kipnis@xxxxxxxxxx] Sent: Monday, December 06, 2004 2:49 PM To: 'icu-pcb-forum@xxxxxxxxxxxxx' Subject: [PCB_FORUM] Dynamic shape problem Hello Allegro V15.1 Gurus, I'm trying to create Gerbers on Allegro V15.1 and it gives me Error: "Dynamic Shapes are out of date, please update them". Therefore I'm fixing this using "dynamic shapes need to update" and I still have (for instance) "Out of data shapes: 4/23" and the same Error. So the ? is: how to find where those 4 out of 23 shapes ? Or another way to fix this problem? Thanks in advance. Regards, OLEG KIPNIS x8286 PCB Layout Designer SMART Modular Technologies, Inc. 4211 Starboard Drive Fremont, CA 94538 Direct: 510-624-8286 Fax: 510-624-8195